Auto Close Idle
Copyright (c) 2020 Ultimate Net Tools
All rights reserved.
END-USER LICENSE AGREEMENT
IMPORTANT - READ CAREFULLY
This License Agreement is a legal agreement between you and Ultimate Net
Tools for Auto Close Idle ("SOFTWARE PRODUCT"). Unless you have a
different written license agreement signed by Ultimate Net Tools, by
installing, copying, or otherwise using the SOFTWARE PRODUCT, you agree to
be bound by the terms of this License Agreement. If you do not agree to
the terms of this License Agreement, do not install, copy, or use the
SOFTWARE PRODUCT.
SOFTWARE PRODUCT LICENSE
The SOFTWARE PRODUCT is protected by copyright laws and international
copyright treaties, as well as other intellectual property laws and
treaties. The SOFTWARE PRODUCT is licensed, not sold.
SOFTWARE PRODUCT is licensed under the following conditions:
ACTIVATION
SOFTWARE PRODUCT may require you to take certain steps to activate
SOFTWARE PRODUCT or validate your subscription. Failure to activate or
register SOFTWARE PRODUCT, validate the subscription, or a determination
by us of fraudulent or unauthorized use of SOFTWARE PRODUCT may result in
reduced functionality, inoperability of the Software, or a termination or
suspension of the subscription.
DATA
LIMITED WARRANTY
ULTIMATE NET TOOLS DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED,
INCLUDING BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE. THIS LIMITED WARRANTY GIVES YOU SPECIFIC
LEGAL RIGHTS. YOU MAY HAVE OTHERS WHICH VARY FROM JURISDICTION TO
JURISDICTION. ULTIMATE NET TOOLS DOES NOT WARRANT THAT THE OPERATION OF
SOFTWARE PRODUCT WILL MEET LICENSEE'S SPECIFIC REQUIREMENTS.
LIMITATION OF LIABILITY
In no event shall Ultimate Net Tools be liable for any damages (including,
without limitation, damages for loss of business profits, business
interruption, loss of data, or any other pecuniary loss) arising out of
the use of or inability to use the Software, even if Ultimate Net Tools
has been advised of the possibility of such damages. Some jurisdictions
prohibit the exclusion or limitation of liability for consequential or
incidental damages, so the above limitations may not apply to you.
OTHER RESTRICTIONS
You may not modify, reverse engineer, decompile or disassemble SOFTWARE
PRODUCT.
EXPORT RESTRICTIONS
You acknowledge that SOFTWARE PRODUCT is of U.S. origin and subject to
U.S. export jurisdiction. You agree to comply with all applicable
international and national laws that apply to SOFTWARE PRODUCT, including
the U.S. Export Administration Regulations, as well as end-user, end-use,
and destination restrictions issued by U.S. and other governments.
TERMINATION
This Agreement shall terminate automatically if you fail to comply with
the limitations described in this Agreement. Upon termination of this
License Agreement, you must uninstall all copies of SOFTWARE PRODUCT.
SEVERABILITY
In the event any provision of this License Agreement is found to be
invalid, illegal or unenforceable, the validity, legality and
enforceability of any of the remaining provisions shall not in any way be
affected or impaired and a valid, legal and enforceable provision of
similar intent and economic impact shall be substituted therefore.
GOVERNMENT RESTRICTED RIGHTS
The Software and any documentation are commercial items, as that term is
defined in 48 CFR 2.101, consisting of commercial computer software and
commercial computer software documentation, as those terms are used in 48
CFR 12.212. If the Software or any documentation is acquired by or on
behalf of the U.S. government or by a U.S. government contractor
(including without limitation prime contractors and subcontractors at any
tier), then in accordance with 48 CFR 227.7202-4 (for Department of
Defense licenses only) and 48 CFR 12.212 (for licenses with all federal
government agencies), the government’s rights to the Software and
such documentation are limited to the commercial rights specifically
granted in this Agreement, as restricted by this Agreement. The rights
limited by the preceding sentence include, without limitation, any rights
to reproduce, modify, perform, display, disclose, release, or otherwise
use the Software or documentation. This Section does not grant Customer
any rights not specifically set forth in this Agreement.
License REV: 2020-07-28